How often should a Hob2Hood rangehood be cleaned?

Every six to eight weeks for the filters, roughly twice as often as a manually operated hood. Hob2Hood starts, adjusts and stops the hood automatically in response to the cooktop, so it runs considerably more. The catch is that the usual prompt to clean a hood, reaching up to switch it on and noticing how it looks, has been removed, so it needs a diary entry rather than a reminder from the appliance.

Can AEG rangehood filters go in the dishwasher?

Not aluminium mesh, which the lower part of the range uses. Dishwasher detergent is strongly alkaline and oxidises aluminium, leaving the mesh a chalky grey that never recovers. Stainless baffle filters on the wider canopy models will survive a dishwasher, but a flat soak in hot water with a non-caustic degreaser cleans both types better and risks neither.

Are AEG and Electrolux rangehood filters interchangeable?

Often, because both brands are part of the same group and their hoods frequently share filter dimensions and motor assemblies. If an AEG-badged replacement is hard to find for an older model, measure the equivalent Electrolux part against yours before concluding it is unobtainable. Check the dimensions rather than assuming.

Why does my AEG rangehood smell after I clean the filters?

Because the grease causing the smell is behind them, thrown against the fan housing by the impeller and baked into a lacquer that warms every time the hood runs. Cleaning the filters removes what you can see and leaves what smells. On a recirculating hood an exhausted charcoal filter is the other likely cause, since those are replaced rather than washed.

AEGGermany (Electrolux group)

How to Clean an AEG Rangehood

A hood that switches itself on never reminds you it needs cleaning, which is the one real drawback of an otherwise excellent feature.

4 min read · Written by Oven Valets, cleaning rangehoods across Sydney and greater NSW for 15+ years

Soak the filters flat in hot water with a non-caustic degreaser, never a dishwasher if they are aluminium mesh. If the hood is paired with an AEG hob through Hob2Hood it runs automatically and loads far faster than a manual hood, so service it on a schedule rather than on noticing.

AEG hoods are competent and unremarkable, which is a compliment. The general method, filters out, soaked flat, then the impeller housing behind them, is on our rangehood cleaning guide. One thing about this brand changes the interval rather than the method.

Hob2Hood removes the reason you would clean it

Some AEG hobs control an AEG hood directly by infrared. The hood starts when a pan goes on, adjusts speed as the cooking changes, and switches itself off afterwards.

The extraction is better for it. The maintenance is worse, and for a reason that has nothing to do with the appliance. People clean a rangehood because they keep reaching up to switch it on and keep noticing how it looks. Automate that away and nothing ever prompts them. Hob2Hood kitchens routinely go a year or more without the filters being touched, not through neglect but because the hood has never asked for anything.

Every six to eight weeks is realistic for a household that cooks most nights on a Hob2Hood pairing, which is roughly twice the frequency the same hood would need on manual control. Set a recurring reminder, because the design intent of the feature is that you stop thinking about the hood at all.

The filters

Baffle on the wider canopy models, aluminium mesh lower down the range. Mesh never goes in a dishwasher; baffles will survive one but a flat soak cleans both better. If yours recirculates rather than ducting outside, there is a charcoal filter behind the metal ones that is replaced every six to twelve months and never washed.

Shared engineering with Electrolux

AEG and Electrolux are the same group, and their hoods frequently share filter dimensions and motor assemblies. If an AEG-badged replacement filter is hard to find for an older model, the equivalent Electrolux part is worth measuring against. See how to clean an Electrolux rangehood.

What actually goes wrong

A Hob2Hood pairing a year overdue, which is the single most common finding on this brand.

Grey mesh filters from a dishwasher cycle.

An original charcoal filter in a recirculating install.

A hum or rattle from an impeller loaded unevenly, which filter cleaning does not touch.

A hood left on its lowest speed because the higher settings became loud, which is the noise being treated as a preference rather than as the symptom it is.

Should you do it yourself?

Do it yourself for the filters, on a six to eight weekly rhythm if the hood is on Hob2Hood.

Get someone in for the impeller housing, or if the hood has been running automatically for a year while nobody thought about it. Check we cover you on our service areas page.

AEG rangehood questions

How often should a Hob2Hood rangehood be cleaned?: Every six to eight weeks for the filters, roughly twice as often as a manually operated hood. Hob2Hood starts, adjusts and stops the hood automatically in response to the cooktop, so it runs considerably more. The catch is that the usual prompt to clean a hood, reaching up to switch it on and noticing how it looks, has been removed, so it needs a diary entry rather than a reminder from the appliance.
Can AEG rangehood filters go in the dishwasher?: Not aluminium mesh, which the lower part of the range uses. Dishwasher detergent is strongly alkaline and oxidises aluminium, leaving the mesh a chalky grey that never recovers. Stainless baffle filters on the wider canopy models will survive a dishwasher, but a flat soak in hot water with a non-caustic degreaser cleans both types better and risks neither.
Are AEG and Electrolux rangehood filters interchangeable?: Often, because both brands are part of the same group and their hoods frequently share filter dimensions and motor assemblies. If an AEG-badged replacement is hard to find for an older model, measure the equivalent Electrolux part against yours before concluding it is unobtainable. Check the dimensions rather than assuming.
Why does my AEG rangehood smell after I clean the filters?: Because the grease causing the smell is behind them, thrown against the fan housing by the impeller and baked into a lacquer that warms every time the hood runs. Cleaning the filters removes what you can see and leaves what smells. On a recirculating hood an exhausted charcoal filter is the other likely cause, since those are replaced rather than washed.

How Oven Valets cleans a AEG rangehood

Our products are non-caustic and biodegradable, so coatings, trim and seals are not at risk and the appliance is safe to use as soon as we leave.
Removable parts come out and are cleaned separately rather than wiped in place, and every piece goes back where it belongs.
We tell you what we find, including when a part is past saving, rather than cleaning around it.
Fully insured, with fixed GST-inclusive pricing and no call-out fee.

Rather have someone else do it?

Fixed, GST-inclusive pricing with no call-out fee. Non-caustic and biodegradable products, so the appliance is safe to use as soon as we leave. Rated 4.9 from 88 Google reviews.

Book a clean Rangehood cleaning service See pricing

Other AEG appliances

Other rangehoods we have written up

Oven Valets is an independent cleaning service. We are not affiliated with, authorised by, or endorsed by any appliance manufacturer named on this page. Brand names are used to identify the appliances we clean.